0 of 20 Questions completed
You have already completed the quiz before. Hence you can not start it again.
Quiz is loading…
You must sign in or sign up to start the quiz.
You must first complete the following:
0 of 20 Questions answered correctly
Time has elapsed
You have reached 0 of 0 point(s), (0)
Earned Point(s): 0 of 0, (0)
0 Essay(s) Pending (Possible Point(s): 0)
Which of the following can be found in the initial email sent by the Project Management Team?
When you are on a job site completing an install, you are representing MPS.
It is your responsibility as a representative of MPS to ensure that you are polite, professional, and helpful while onsite.
After receiving the job acceptance email make sure to plan ahead with the correct __________, start time, point of contact, and needed materials.
What should you do if you foresee any issues when you arrive onsite?
If the system is installed using site and state regulations, there is no need to follow OSHA regulations.
What wire is used when wiring the sound masking system?
2-3 represents which controller and output on the wiring diagram?
What is the correct setting a plenum speaker should be tapped to?
If possible, the plenum speaker should be installed no further than __________ from the deck.
When wiring the plenum speaker, you should not connect the ground wire to the speaker.
A sensor automatically adjusts the speaker volume up to __________ dB higher than its original setting.
When connecting the sensors at the controller the ground wire needs to be run in with the positive wire at the phoenix connector.
Which control knob controls an entire zone or multiple zones of speakers?
The 18/2 cable runs out of the OUT port on the Room Control Knob to the speaker(s) that will be controlled by the knob.
How many RUs does each rack-mounted controllers take up?
When on the VoiceArrest Project Manager, which tab should you be on to adjust the sound masking volume?
What must you do every time you make adjustments on the VoiceArrest Project Manager in order to save your progress?
It is important that you clean the work area after the install is complete.
What should be done upon completion of the install?